Understanding Tire Load Index and Speed Rating: A Truck Owner's Guide
Author : Stallion Auto | Published On : 21 Nov 2026
Truck owners spend a lot of time comparing tread patterns and sizes. Fewer look closely at the small code printed after the size, yet that code determines how much weight each tire can safely carry and how fast it is rated to run. Here is how to read it, and how it connects to the bigger question of P-metric versus light-truck tires.
Where to find the service description
On the sidewall, after the tire size, you will see a number followed by a letter — for example, 115S. This is the service description. The number is the load index and the letter is the speed rating.
Load index explained
The load index is a code that corresponds to the maximum weight a single tire can carry at its maximum rated pressure. A higher number means more capacity. When replacing tires, the load index should meet or exceed the figure on your vehicle's placard, found on the driver's door jamb or in the owner's manual.
Dual load numbers
Light-truck tires often display two numbers, such as 120/117. The first applies when a single tire carries the load. The second applies to dual rear-wheel setups, where two tires on each side share the weight, so each is rated slightly lower.
Speed rating explained
The speed rating letter indicates the maximum sustained speed the tire is designed for under its rated load. Common truck ratings include S, T and H, while performance vehicles often use higher ratings. Matching your vehicle's original rating helps preserve the handling it was designed with.
Load range and ply rating
LT tires add another measure: load range, shown as a letter such as C, D or E. It reflects the strength of the tire's construction and the pressure it can operate at. Load Range E is commonly called '10-ply', a holdover from older construction methods. Higher load ranges carry more weight but give a firmer ride when the truck is unloaded.
P-metric vs LT: how the codes guide the choice
P-metric tires
Designed for passenger vehicles, SUVs and most half-ton pickups. They generally ride more quietly and comfortably and suit trucks used mainly for commuting and light hauling.
LT tires
Built for heavier loads and higher pressures. They suit three-quarter and one-ton trucks, vehicles that tow or haul regularly, and many lifted or off-road builds.
Common mistakes
- Choosing a tire with a lower load index than the placard requires.
- Swapping from LT to P-metric on a heavy-duty truck to get a softer ride.
- Running LT tires at the pressure the old P-metric tires used, or vice versa.
- Changing wheel size without checking bolt pattern, offset and wheel load rating.
A worked example
Consider two tires for a full-size pickup: a P275/60R20 115S and an LT275/55R20 120/117S. The first is a P-metric highway tire suited to a half-ton used mostly for daily driving. The second is a 10-ply light-truck tire with dual load ratings, suited to a heavy-duty truck that tows. Same rim diameter, very different jobs.
When you are also changing wheels
If you are upgrading wheels at the same time as tires, confirm the wheel's bolt pattern, offset and load rating as well. A wheel and tire package only works when every part is matched to the truck.
Pressure: the part everyone gets wrong
Because LT tires are designed to run at higher pressures, the correct figure depends on the load you carry and the tire's construction, not just on what the old tires used. Your truck's placard gives the starting point. Some manufacturers specify one pressure for normal driving and a higher one for towing or full loads. Check pressures cold, before driving, and remember that cold weather lowers pressure, so recheck after a big temperature drop.
Getting pressure right protects the tire, keeps the tread flat on the road for even wear, and helps the truck handle predictably when it is loaded.
Get it right first time
Reading the service description takes a minute and can prevent an unsafe or uncomfortable mismatch. For a full comparison of P-metric and light-truck tires, including which suits half-tons, heavy-duty trucks and lifted builds, read Stallion Auto's guide to LT vs P tires.
